• Arrowbridge II nodes.

    From Joseph Larsen@1:340/800 to All on Fri Jun 3 09:27:05 2016
    Hi all,

    I can only seem to get 2 working nodes with Arrowbridge II. Anyone else have this problem?

    Thanks,

    |09ignatius |07(|15cia|07)

    --- DayDream BBS/UNIX (Linux) 2.15a
    * Origin: catch22bbs.com >>> >> > (1:340/800)
  • From mark lewis@1:3634/12.73 to Joseph Larsen on Fri Jul 1 11:24:24 2016

    03 Jun 16 09:27, you wrote to All:

    I can only seem to get 2 working nodes with Arrowbridge II. Anyone
    else have this problem?

    did you ever figure this out? AFAIK my ABII is running fine on all my nodes... i think i'm using DOOR.SYS and somewhere i apparently defined each of my nodes for the specific port and irq or FOSSIL they are to use...

    )\/(ark

    Always Mount a Scratch Monkey

    ... HOOTERS: Delightfully tacky yet unrefined.
    ---
    * Origin: (1:3634/12.73)
  • From Joseph Larsen@1:340/800 to mark lewis on Fri Jul 1 23:21:33 2016
    did you ever figure this out? AFAIK my ABII is running fine on all my n


    Yeah. I figured it out. This had to do with my Impulse setup. On nodes 3 and
    4, the COM port was set to 0. I set it to 1. To match the $_com1 = "virtual"
    in the dosemu.conf file for Impulse.

    Thanks,

    |09ignatius |07(|15cia|07)

    --- DayDream BBS/UNIX (Linux) 2.15a
    * Origin: catch22bbs.com >>> >> > (1:340/800)
  • From mark lewis@1:3634/12.73 to Joseph Larsen on Fri Jul 1 21:34:36 2016

    01 Jul 16 23:21, you wrote to me:

    did you ever figure this out? AFAIK my ABII is running fine on all my n

    Yeah. I figured it out. This had to do with my Impulse setup. On nodes
    3 and 4, the COM port was set to 0. I set it to 1. To match the $_com1
    = "virtual" in the dosemu.conf file for Impulse.

    there ya go :)

    Thanks,

    welcome for the little i did ;)

    )\/(ark

    Always Mount a Scratch Monkey

    ... My wife ran away with my best friend and I sure miss him.
    ---
    * Origin: (1:3634/12.73)